Bookmark and Share
KitchenAid 9758377-009

KitchenAid 9758377-009

From YouserGuide

Jump to: navigation, search
You can edit and write guides yourself, or if you prefer, just send your input to guides@youserguide.com

9758377 (Product)
Pg. 1-2-3-4-5-6-7-8- 9 -10-11-12

Products referring to this guide:-Whirlpool 4RF302BXK-KitchenAid 4RF302BXK-Whirlpool 4RF315PXMQ0-KitchenAid 4RF315PXMQ0-Roper FEP310K:more

Enter your
Part number


background image
9
3. Loosen (do not remove) the hex washer head screw and insert
the neutral (white) wire under the screw clamp at the bottom
of the center position terminal connector.
4. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
5. Securely tighten the hex washer head screws to 35 in.-lbs
minimum torque to make proper electrical connection.
6. Tighten the locking ring of the conduit connector.
7. Replace the terminal block cover.
3-wire connection: Direct wire
Use this method only if local codes permit connecting ground
conductor to neutral supply wire.
1. Loosen (do not remove) the hex washer head screws and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
2. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
3. Securely tighten the hex washer head screws to 35 in.-lbs
minimum torque to make a proper electrical connection.
4. Tighten the locking ring of the conduit connector.
5. Replace the terminal block cover.
VerifyAnti-TipBracketLocation
1. Move range close to cabinet opening.
2. Remove cardboard or hardboard from under range. Gently
move range into its final position.
3. Pull drawer open to first stop position. Lift front of drawer to
clear white wheels in drawer guides. Remove drawer and set it
aside on a protected surface.
4. Making sure the anti-tip bracket is installed:
s
Look for the anti-tip bracket securely attached to floor.
s
Slide range back so rear range foot is under anti-tip
bracket.
5. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
“Location Requirements” section.
A.Insert wire under screw clamp
B.Hex washer head screw
A.Line 1
B.Ground-link
C.Hex washer head screw
D.Silver-colored terminal
block screw
E.Neutral (white) wire
F.Line 2
G.UL listed conduit
connector and power
supply cable
A.Insert wire under screw clamp
B.Hex washer head screw
A
B
A
B
C
D
E
F
G
A
B
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
Help YG remain FREE
Advertise with YG